I remember when I built my first few rods back in the mid 80's. I had bought Dales Clemens book and remember reading his words about finishing. He said it was a mistake to think about finishing as you were mixing your finish. I start to think about finishing even before the guide is wrapped. If you prep your guides properly it is so much easier to get a nice clean finished product. My tools are a flat file and a sanding board which women use to file their nails. I will say that when I find myself at the drugstore I get some funny looks when I am buying fingernail boards, Sally
Hansens nail varnish(for my flies). I don't say anything and keep them guessing!! Ha Ha
When prepping your guide feet try to get a narrow slope with a very fine edge where the thread will start to climb up the foot. The time spent here will save you more headache than you know. This is especially true for someone starting out. I rough them out with a flat file and then take any burrs off with a sanding board.As these days I mostly build fly rods I like to keep the wraps slim looking. A word of caution- go slow file a bit and look. You can always remove but its hard to put the material back. As this is custom work and your looking for a nice fit and finish, time should not really be an issue.
You can click on each photo to get a close look
Left- Unprepped
Right-Prepped
Notice the difference in the slope, thickness and radiused. Much easier to work the thread over the prepped guide. After it is wrapped the "tunnels" which are formed on each side of the foot are kept to a min. This reduces the amount of air that can be trapped in this void space. Reduced air equals less chance of getting bubbles in your finish and they are easier to fill up with your thread coating of choice.
Here's the difference. Be careful though don't make them too thin as you will lose to much of the structural strength. Practice makes perfect
I usually taper them this way as well.
I have been going through my fishing photos and saving all my best to a disc. Here is a nice
grayling(one of my favorite fish). I looked in my notes and this was taken on a #16 CDC
emerger during an olive hatch. This is the European
grayling which is a bit different from the
Artic Grayling.
Great sport when they are feeding on the surface with gusto!!
GO CANADA!!!!
Hockey tonight against USA. Lets crush them Shatner stealing Mexico touchers. I may be here in the UK. I,m still a puck slapping maple sucker A good medal haul so far this year
